AC Repair in Marble Falls

Serving Marble Falls and every community across Burnet County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
A single-story red brick house with a gray shingled roof and dark shutters, with a large wind-bent tree behind it under an overcast sky and heavy rain streaking the frame.

A contractor quoting a central AC repair in Burnet County has to account for what the equipment has already been through before they can say what a fix will cost. 131 severe weather events were recorded in Burnet County, Texas between 2015 and 2024. At that rate, severe weather is part of the normal operating life of every system here, and wear on capacitors, contactors, and compressor windings reflects that load. A unit that has been cycling hard against repeated stress events does not present the same repair picture as one that has mostly run in calm conditions, and the parts that absorb that load tend to be the first ones a contractor pulls and checks.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
Attic interior with wooden rafters, OSB board flooring, loose fiberglass insulation along the eaves, two cardboard boxes, and a long gray flexible duct running across the floor.

Ductwork and wiring in a house this old were put in for equipment that is no longer sold, and what runs in the house today has been swapped and adapted since. Half the homes in Burnet County, Texas were built in 1997 or earlier (2020-2024 ACS 5-year). When a system in stock like this needs repair, the question a contractor has to answer is whether the failed component is still manufactured or whether the parts pipeline has dried up. That answer changes what the job costs and sometimes whether it is worth doing at all.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

The Parts of a Central AC a Contractor Checks First

Isometric line illustration of a cutaway single-story house showing interior rooms, ducted air handler, ceiling ductwork, and an outdoor condenser unit connected by refrigerant lines.

The outdoor condenser unit sits outside the house, usually on a concrete pad at ground level, and it is where heat gets shed to the outside air. The compressor lives inside that cabinet and is one of the first things a contractor looks at when the system stops cooling. A failed compressor, a refrigerant leak, or a fouled condenser coil all show up here.

Inside the house, the air handler or furnace cabinet holds the evaporator coil and the blower that moves air through the system. The evaporator coil is a common fault point when airflow drops or the system ices over. The copper refrigerant lines running between the two units and the expansion valve that controls refrigerant flow round out what a contractor traces when the indoor and outdoor sides are not working together.

The drawing shows the general layout of a central AC system, and a licensed contractor determines which components apply and what work is needed in your particular home.

Get matched in Burnet County

Burnet County, by the numbers

131

131 severe weather events were recorded in Burnet County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
1997

Half the homes in Burnet County, Texas were built in 1997 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
25,555

Burnet County, Texas holds 25,555 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
76.3%

Owners occupy 76.3% of the occupied homes in Burnet County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Rules & Standards Governing Central AC Repair in Burnet County, Texas9 sourced rules and standards

What happens when a contractor comes out to your home

Split-system central air conditioners rated below 45,000 Btu/h manufactured on or after January 1, 2023 must meet a federal minimum of 13.4 SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Split-system central air conditioners rated at or above 45,000 Btu/h manufactured on or after January 1, 2023 must meet a federal minimum of 13.4 SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Split-system central air conditioners manufactured between January 1, 2015 and December 31, 2022 had to meet 13 SEER, the metric that preceded SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Single-package central air conditioners manufactured on or after January 1, 2023 must meet a federal minimum of 13.4 SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Space-constrained central air conditioners manufactured on or after January 1, 2023 must meet a federal minimum of 11.7 SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Federal efficiency standards for split-system central air conditioners and heat pumps are set on each certified combination of outdoor unit and indoor coil rather than on the outdoor unit alone.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Residential and light commercial air conditioning and heat pump systems assembled in the field, including mini-splits and unitary systems, may not be installed on or after January 1, 2025 using a refrigerant with a global warming potential above 700.

U.S. Environmental Protection AgencyU.S. Environmental Protection Agency, Technology Transitions HFC Restrictions by Sector, implementing the American Innovation and Manufacturing Act.Verified 2026-09-10

A field-assembled system whose specified components were all manufactured or imported before January 1, 2025 carries no installation compliance date under the refrigerant restrictions and may still be installed.

U.S. Environmental Protection AgencyU.S. Environmental Protection Agency, Technology Transitions HFC Restrictions by Sector, implementing the American Innovation and Manufacturing Act.Verified 2026-09-10

What Burnet County, Texas Requires for HVAC Repair

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather Events in Burnet County

Hard weather puts real load on cooling equipment: sudden temperature swings, humidity spikes, and power disturbances all take a toll on components that are already working hard through a Texas summer. How often that happens in Burnet County shapes how much repair work local systems actually need.

Severe weather events by county — Burnet County
403020100
2015201620172018201920202021202220232024
39

131 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.