AC Installation in Caldwell

Serving Caldwell and every community across Burleson County.

Tell us about the job

Takes about a minute. No obligation.

Step 1 of 3: Equipment
View through a rain-streaked square window in a gray-framed wall, showing a light-colored horizontal lap-siding wall of an adjacent building on the right and green trees and shrubs under an overcast sky on the left.

Sizing a new central AC system in this county means working from what the local climate actually demands, not from a standard table. 59 severe weather events were recorded in Burleson County, Texas between 2015 and 2024. At that rate, a contractor has to treat outdoor conditions as a standing workload variable when selecting equipment capacity and specifying installation details like refrigerant line length, insulation, and disconnect placement. A unit that fits the square footage but ignores the load this climate puts on a condenser over years will underperform before its time.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
Interior of an unfinished attic with wooden rafters, an OSB floor, loose fiberglass insulation between joists, a large gray insulated flexible duct running down the center, and two cardboard boxes at the far end.

Ductwork laid for an earlier generation of equipment carries assumptions about airflow and load that a new central AC system does not share. Half the homes in Burleson County, Texas were built in 1991 or earlier (2020-2024 ACS 5-year). A contractor quoting a new system has to assess whether existing ducts can move the air a modern unit pushes, and in stock of this age, that assessment often changes the scope of the job before any equipment is priced. The unit itself is straightforward to specify. What the house already contains decides how the install actually goes.

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates

What Goes Into a Central AC Installation

Isometric line illustration of a cutaway house showing an indoor air handler with branching ducts in the attic space, connected by a line set to an outdoor condenser unit beside the building, with simple furniture in two rooms.

The outdoor condenser unit sits on a concrete pad beside the house and holds the compressor and condenser coil, the two components that shed heat outside. Inside, the air handler or furnace-mounted evaporator coil lives in a utility closet, attic, or basement and is where warm indoor air passes across refrigerant lines.

The refrigerant lines run between those two units, connecting the indoor coil to the outdoor condenser through the wall or floor. A contractor also installs the thermostat on an interior wall, which is the control point the homeowner touches every day.

The drawing shows a typical layout, and a licensed contractor determines exactly what applies to your house.

Get matched in Burleson County

Burleson County, by the numbers

59

59 severe weather events were recorded in Burleson County, Texas between 2015 and 2024.

NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.
1991

Half the homes in Burleson County, Texas were built in 1991 or earlier (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
9,579

Burleson County, Texas holds 9,579 housing units (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
81.7%

Owners occupy 81.7% of the occupied homes in Burleson County, Texas (2020-2024 ACS 5-year).

U.S. Census Bureau, 2020-2024 American Community Survey 5-Year Estimates
Rules & Standards for Central AC Installation in Burleson County, Texas9 sourced rules and standards

What Happens on Installation Day

Split-system central air conditioners rated below 45,000 Btu/h manufactured on or after January 1, 2023 must meet a federal minimum of 13.4 SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Split-system central air conditioners rated at or above 45,000 Btu/h manufactured on or after January 1, 2023 must meet a federal minimum of 13.4 SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Split-system central air conditioners manufactured between January 1, 2015 and December 31, 2022 had to meet 13 SEER, the metric that preceded SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Single-package central air conditioners manufactured on or after January 1, 2023 must meet a federal minimum of 13.4 SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Space-constrained central air conditioners manufactured on or after January 1, 2023 must meet a federal minimum of 11.7 SEER2.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Federal efficiency standards for split-system central air conditioners and heat pumps are set on each certified combination of outdoor unit and indoor coil rather than on the outdoor unit alone.

U.S. Department of Energy10 CFR 430.32, Energy and water conservation standards and their compliance dates, Electronic Code of Federal Regulations.Verified 2026-09-10

Residential and light commercial air conditioning and heat pump systems assembled in the field, including mini-splits and unitary systems, may not be installed on or after January 1, 2025 using a refrigerant with a global warming potential above 700.

U.S. Environmental Protection AgencyU.S. Environmental Protection Agency, Technology Transitions HFC Restrictions by Sector, implementing the American Innovation and Manufacturing Act.Verified 2026-09-10

A field-assembled system whose specified components were all manufactured or imported before January 1, 2025 carries no installation compliance date under the refrigerant restrictions and may still be installed.

U.S. Environmental Protection AgencyU.S. Environmental Protection Agency, Technology Transitions HFC Restrictions by Sector, implementing the American Innovation and Manufacturing Act.Verified 2026-09-10

Licensing and Legal Requirements in Burleson County, Texas

In Texas a person may not engage in air conditioning and refrigeration contracting unless that person holds a license issued under the state air conditioning and refrigeration contractor law.

Texas Department of Licensing and RegulationTex. Occ. Code Ch. 1302 (Texas Department of Licensing and Regulation)Verified 2026-09-10

Severe Weather Events in Burleson County

Weather puts a measurable load on cooling equipment, and the intensity of that load is local. A system sized and installed for Burleson County conditions handles demand that a generic spec may not account for.

Severe weather events by county — Burleson County
10.58530
2015201620172018201920202021202220232024
9

59 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.